|
|
|
642 990 29 07-FEBI KIT
2007 & LATER 3.0L V6 Diesel SPRINTER Fuel Injector Bolt Kit
Complete set of six stretch bolts and six lower injector seals.
Any time an injector is replaced, both the bolt and the seal must be replaced.
These two components should never be reused.
|
|
|
|
|
651 070 30 87
Diesel Fuel Injector - New 2.1L 4Cyl 2014-2016
Original New Factory Injector - For 2.1L 4 Cyl engines 2014-2016
|
|
|
|
|
642 070 12 87-BOSCH
Diesel Fuel Injector - New 3.0 V6 2010 & LATER
Original New Factory Injector - For BlueTec OM642.896, OM642.898 & OM642.899 V6 diesel engines 2010 & Later
Only for BluTec engines 2010 and later - Six Required, Sold Individually
|
|
|
|
|
642 070 13 01-NEW
Diesel Injection Pump NEW 3.0L V6 Diesel 2010-2022
OM 642.993 V6 diesel engine 2010 and Later
NOT for BlueTec engines 2007-2009
This is a New Bosch pump, the OEM supplier to Mercedes for this part. |
|
|
|
|
642 070 13 01-REMAN
Diesel Injection Pump REMAN / EXCHANGE 3.0L V6 Diesel 2010-2022
OM642.993 V6 diesel engine 2010-2022 Only.
NOT for BlueTec engines 2007-2009.
This is a remanufactured Mercedes Benz pump. It will be furnished in
either a Mercedes Benz or a Bosch box. In either case, these pumps are
remanufactured by Bosch, the original supplier to Mercedes Benz.
All returned cores must be complete, undamaged and fully assembled or they will not be accepted for refund. |
|
|
|
|
LM2032
Diesel Injector Cleaner 2002 & Later
Diesel injection system cleaner - 500ml can
Removes deposits in the diesel injection system and in the combustion chamber. Increases the cetane number and improves the ignitability of the diesel fuel. Ensures the engine runs quietly. Protects against corrosion and wear. Optimizes the exhaust gas values and performance of the engine. Effect lasts up to 6000 miles.
|
|
|
|
|
DPF KIT
DPF Cleaning Kit 2007 & Later
Complete kit with all necessary items for cleaning the DPF (Diesel Particulate Filter)
Incudes:
1 x Pressurized Spray Gun
1 x Spray wand with five nozzle attachments
1 x DPF Filter Cleaner (also available separately)
1 x DPF Filter Purge (also available separately)
|
|
|
|
|
007 153 43 28-MB
Exhaust Back Pressure Sensor / Low Fuel Pressure Sensor 2002-2003 & 2007 & LATER 3.0L V6 - Genuine Mercedes
Genuine Mercedes part.
Located adjacent to EGR cooler on the 3.0L V6 models.
Located on left side of engine block on 2002-2003 5 CYL models (known as a low fuel pressure sensor).
Female plug, three contact pins inside plug housing.
Same Part Number as: 009 153 50 28 |
|
|
|
|
007 153 43 28-OEM
Exhaust Back Pressure Sensor / Low Fuel Pressure Sensor 2002-2003 & 2007 & LATER 3.0L V6 - OEM
Located adjacent to EGR cooler on the 3.0L V6 models
Located on
left side of engine block on 2002-2003 5 CYL models (known as a low fuel pressure sensor)
Female plug, three contact pins inside plug housing.
Same Part Number as: 009 153 50 28 |
|
|
|
|
009 542 55 18
Front Oygen Sensor - 2019+ Sprinter 2.0L 4CYL & METRIS 2016+
Front Oxygen sensor, located before the catalyst
|
|
|
|
|
005 153 23 28
Fuel & Oil Temperature Sender 2002 & LATER
2 contact pins, straight electrical connector.
Located on the injection pump on front of engine block on the 2.7L 5 CYL diesel engines.
Located near oil pan for the 3.0L V6 diesel engines.
|
|
|
|
|
21013
Fuel Injection Hose Clamp 13mm 2002 & LATER
Clamping Range 12.5 - 14mm
These are special fuel hose clamps with rolled edges and no open serrations so the clamp will not cut into the hose.
If you are replacing all of the original Mercedes factory "Clic" style clamps on a ......
2002-2003 Sprinter...................... Order 4 x 13mm clamps
2004-2006 Sprinter...................... Order 9 x 13mm clamps & 1 x 15mm clamp
2007-2009 Sprinter...................... Order 6 x 13mm clamps & 6 x 15mm clamps
|
|
|
|
|
21015
Fuel Injection Hose Clamp 15mm 2002 & LATER
Clamping Range 13.5-15.5mm
These are special fuel hose clamps with rolled edges and no open serrations so the clamp will not cut into the hose.
If you are replacing all of the original Mercedes factory "Clic" style clamps on a ......
2002-2003 Sprinter........... Order 4 x 13mm clamps
2004-2006 Sprinter........... Order 9 x 13mm clamps & 1 x 15mm clamp
2007-2009 Sprinter........... Order 6 x 13mm clamps & 6 x 15mm clamps
|
|
|
|
|
21017
Fuel Injection Hose Clamp 17mm 2002 & LATER
Clamping Range 16-18mm
These are special fuel hose clamps with rolled edges and no open serrations so, the clamp will not cut into the hose
If you are replacing replacing all of the original Mercedes factory "Clic" style clamps on a ......
2002-2003 Sprinter........................order 4 x 13mm clamps
2004-2006 Sprinter........................order 9 x 13mm clamps & 1 x 15mm clamp
2007-2009 Sprinter........................order 6 x 13mm clamps & 6 x 15mm clamps
|
|
|
|
|
642 070 12 87 80
Fuel Injector - REMAN / EXCHANGE 3.0L V6 2010 & LATER
Original Remanufactured / Exchange factory Bosch injector - For BlueTec OM 642.896, OM642.898 & 642.899 V6 diesel engine
A CORE DEPOSIT OF $100 PER INJECTOR WILL BE ADDED TO YOUR INVOICE. THIS DEPOSIT WILL BE REFUNDED UPON RETURN OF YOUR OLD REBUILDABLE INJECTOR.
All returned cores must be complete, undamaged and fully assembled or they will not be accepted for refund.
Only for BluTec engines 2010 and later
THESE ARE ALSO AVAILABLE NEW, SEE BELOW
|
|
|
|
|
642 016 00 38
Fuel Injector Retainer 2007 & LATER 3.0L V6
All 2007 and later 3.0L V6 Diesel engines
|
|
|
|
|
000 990 29 07-FEBI
Fuel Injector Retainer Bolt 2002 & LATER 2.7L & 3.0L
These are manufactured by Febi-Bilstein, the OEM supplier to Mercedes.
T-40 Torx head screw - 6mm outer diameter - 79mm stretch bolt (24mm shank & 55mm thread).
Order 1 screw for each injector.
These bolts are to be tightened in two stages. Torque to 7 Nm (62 inch lbs), then an additional 90 degrees. |
|
|
|
|
000 990 29 07-MB
Fuel Injector Retainer Bolt 2002 & LATER 2.7L & 3.0L - Genuine Mercedes
These are Genuine Mercedes bolts.
T-40 Torx head screw - 6mm outer diameter - 79mm stretch bolt (24mm shank & 55mm thread).
Order 1 screw for each injector.
These bolts are to be tightened in two stages. Torque to 7 Nm (62 inch lbs), then an additional 90 degrees. |
|
|
|
|
642 070 08 00
Fuel Injector Supply Line 3.0L V6 2007 & LATER
Steel line from the either fuel rail to each of the six injectors.
These lines will often leak at either end, especially if they have been over-torqued.
Six required. one for each injector.
|
|
|
|
|
006 153 78 28
Fuel Pressure Sensor 2010 & LATER
Oval shaped Plug, no flat edges - if you have a 2009 or 2010 check the plug connector first.
Located on back end of the Right side fuel rail.
The 90 degree sensor on the Left fuel rail is not available as a separate component and is only available with the left fuel rail assembly.
|
|
|
|
|
021 997 97 45
Fuel Pump Seal Ring
High Pressure Mechanical Fuel Pump Seal |
|
|
|
|
642 070 09 00
Fuel Rail Connecting Line L to R 2007 & LATER
Steel line from the left fuel rail to the right fuel rail.
This line will often leak at either end, especially if it has been over-torqued.
One required
|
|
|
|
|
642 070 10 00
Fuel Rail Supply Line 2010 & LATER 3.0L V6
Also Known As: Fuel Delivery Line
Steel line from the high pressure injection pump to the fuel rail. This line will often leak at either end, especially if it has been over-torqued.
|
|
|
|
|
000 078 05 80-BOSCH
Fuel Return Line Seal 3.0L V6 & 2.1L 4CYL DIESEL
1 required for each injector.
Replace these seals at the same time that you replace the fuel return line or you may have leakage.
Seals leak line (fuel return line) to each injector.
These are made by Bosch and are the identical seal ring sold at a Mercedes franchise dealer.
|
|
|
|
|
000 078 05 80-MB
Fuel Return Line Seal 3.0L V6 & 2.1L 4CYL DIESEL
1 required for each injector.
Replace these seals at the same time that you replace the fuel return line or you may have leakage.
Seals leak line (fuel return line) |
|
|
|
|
000 470 59 05-MB
Fuel Tank Cap 2007-2021
Black plastic cap with seal with lanyard. Without red cap from 10/12/2014. Compare photo to original cap.
|
|
|
|
|
642 990 29 07-MB KIT
Genuine Mercedes - 2007 & LATER 3.0L V6 Diesel SPRINTER Fuel Injector Bolt Kit
Complete set of Six stretch bolts and Six lower injector seals.
Any time an injector is replaced, both the bolt and the seal must be replaced.
These two components should never be reused.
|
|
|
|
|
006 997 18 90
Hose Clamp - Feed Line 2002 & LATER
Clamping Range 13-14.5mm
These are special hose clamps manufactured by Mercedes.
|
|
|
|
|
177 072 00 00
Injector Seal Kit 2.0L Sprinter 2019+ & Metris
One kit per injector
4 required
|
|
|
|
|
642 070 27 95
Left Fuel Distribution Rail 2010-2022 3.0L V6
Driver's side rail. Includes Fuel Control Valve on end of rail.
The fuel control valve (642 070 02 46) with the 90 degree connection is only available with the fuel rail.
|
|
|
|
|
611 017 00 60
Lower Fuel Injector Seal Ring 2002 & LATER
OEM Bosch fuel injector seal - Lower copper seal at tip of injector.
One required for each injector nozzle.
|
|
|
|
|
006 542 49 18-BOSCH
Oxygen Sensor 3.0 V6 2010 & LATER & 2014-2016 2.1L 4 CYL
Fits all 3.0 liter Diesel Engines from 2010 and later and the 2014-2016 4 CYL engines (BlueTec)
|
|
|
|
|
006 542 49 18-MB
Oxygen Sensor 3.0L V6 - Genuine Mercedes 2010 & LATER & 2014-2016 2.1L 4 CYL
Fits all 3.0 liter Diesel Engines from 2010 and later and the 2014-2016 4 CYL engines (BlueTec)
|
|
|
|
|
642 070 30 95
Right Fuel Distribution Rail 2010-2022 3.0L V6
Right side or Passenger's side
|
|
|
