Sprinter I 2002-2006
Sprinter II 2007-2018
Owners installing these shock absorbers may find that the metal inner sleeve (tube) inside the shock's TOP rubber bushing is narrower (by about half an inch) than the original OE factory shock or the mounting bracket opening on the frame rail. To make it fit properly and prevent side-to-side slop or stress on the mounting bolt, use one of these solutions:
1. Add custom metal or stainless steel spacers/washers: Slide appropriately sized thick washers or custom-cut tubular metal spacers on each side of the upper shock eyelet inside the mounting bracket to take up the half-inch gap and center the shock.
2. Torque properly under load: Make sure the lower and upper mounting bolts are torqued down with the vehicle resting on its weight (ride height) rather than hanging on a jack, so the rubber bushings bind correctly without pre-loading the sleeve improperly. |