Positive Battery Cable/Harness-180 AMP 2007 & LATER 3.0L V6 Diesel
ONLY FOR MODELS WITH 180 AMP ALTERNATOR
If in doubt, look at the black
plastic backing plate on the alternator. It will be marked either 180A
If you have had continuing sluggish starts and other electrical problems and you are certain that you have a strong alternator, generating an output of 14V, you may want to look closely at your positive battery cable/harness, especially for internal corrosion on the copper braiding.
This is often a common area of electrical trouble and is commonly referred to as the infamous "Y cable"
This is the fourth revision of this cable by Mercedes. All three of the previous units have been discontinued and should no longer be installed.
This cable is the most current revision. 906 440 14 09, 906 440 35 38 and 906 440 81 55, are all obsolete.
Sprinter II 2007-2018 3.0 V6 WITH 180 AMP ALTERNATOR ONLY
Sprinter III 2019+ 3.0L V6 WITH 180 AMP ALTERNATOR ONLY
Fault codes often associated with a faulty cable....
P2526 -002 Boost Pressure Reg short to ground
P2526-001 Signal line shorted to voltage
P2530-002 Intake port EKAS shorted
P2527-002 EGR shorted
P2514-002 Vent heater valve shorted
P2978-002 EGR short to ground
P2376-001 Throttle valve under voltage