All parts required to install a vertical grab handle inside the rear cargo door area of your Sprinter I and Sprinter II.
One kit contains parts for one side: One handle and two mounting screws. The two threaded inserts are not included with the kit
and are in the photo strictly for illustration purposes.
Order Two kits if you wish to do both sides of the vehicle, as these are interchangeable.
Detailed Description
Sprinter 2002-2006
Sprinter II 2007-2018
The mounting holes for these handles are 420 mm (approx. 16.5 inches) from center to center. The mounting hole spacing on these and those for the 2019 and later models (shown below) are the same thus the two are interchangeable with each other. This type has a 90 degree bend at the base and the later version are straight at the base.
IF YOU HAVE A CARGO VAN, NOTHING ELSE IS WILL BE REQUIRED TO INSTALL THIS KIT.
IF YOU HAVE A PASSENGER VAN, YOU MAY OR MAY NOT HAVE THE THREADED INSERTS REQUIRED TO ACCEPT THE TWO MOUNTING SCREWS. IT WOULD BE BEST TO EXAMINE THE VEHICLE AND ORDER TWO THREADED INSERTS PER KIT, SHOWN BELOW, IF REQUIRED. OR FOUR PER VEHICLE.
