Only for 4 Cylinder engine models with OM651 diesel engine.
This is the identical OEM INA pulley sold at a franchise Mercedes dealer.
To check the integrity of your
alternator pulley, simply remove the belt and place a screwdriver into
the front of the alternator cooling fan to stop the armature from
rotating. Then turn the pulley by hand. If it moves one direction but,
not the other, it is functional. If it will not rotate at all, it has
failed.
Freewheel Clutch/Pulley for alternator. This unit is standard equipment on all Sprinter alternators.
THIS IS A CRITICAL COMPONENT OF THE SERPENTINE BELT SYSTEM AND A KNOWN CAUSE OF BREAKAGE PROBLEMS. IT IS COMMON FOR THIS DECLUTCHING PULLEY TO FAIL, LONG BEFORE THE ALTERNATOR WEARS OUT.
A special tool is required for installation of this unit and are not usually replaceable outside a repair facility. If you are purchasing a new alternator, you will not need to buy this, as the alternator is furnished with a new pulley.
This tool is required to remove and replace the decoupling alternator pulleys on all Sprinters, with either Bosch or Valeo alternators and Metris, as well.
OEM Bosch
180 Amp Remanufactured/Exchange
Only for 3.5L V6 gas engine models, NOT for diesel engines
To check the integrity of your
alternator pulley, simply remove the belt and place a screwdriver into
the front of the alternator cooling fan to stop the armature from
rotating. Then turn the pulley by hand. If it moves one direction but,
not the other, it is functional. If the pulley will not rotate at all, it has
failed.
220 Amp and this is NOT interchangeable with the 180 Amp unit
Only for 3.5L V6 gas engine, NOT for diesel engine models
This unit is r,manufctured by Bosch and an $ 80.00 core deposit is required.
The
220 Amp alternators are used on those models with a secondary A/C
compressor (Roof-mounted A/C units). If in doubt, look at the black
plastic backing plate on the alternator. It will be marked either 180
or 220.
Alternator voltage regulator and cut-out. Located under black plastic rear cover of alternator. Fits ONLY Valeo alternator, NOT for Bosch. Fits 180 amp models only.
The
220 Amp alternators are used on those models with a secondary A/C
compressor (Roof-mounted A/C units). If in doubt, look at the black
plastic backing plate on the alternator. It will be marked either 180A
or 220A.
Alternator voltage regulator and cut-out. Located under black plastic rear cover of alternator. Fits ONLY Valeo alternator, NOT for Bosch. ONLY FOR 220 AMP ALTERNATOR
The 220 Amp alternators are used on those models with a secondary A/C compressor (Roof-mounted A/C units). If in doubt, look at the black plastic backing plate on the alternator. It will be marked either 180 or 220.
