Blower Motor Regulator/Resistor-A/C Fan 1998-2003 Only for models with electronically regulated climate control.
Control Unit 1997-2000 Heating/AC control unit
Front Blower Motor Assembly-Heater & AC 1992-2003 Front heater blower located under the dash
Front Heater Core 1992-2005 Fits all models with factory air conditioning
Heater & AC Blower Motor Resistor 1992-2000 Located in heater blower case
Heater Control Valve Repair Solenoid-Rear Heater Core 1992-2000 Replacement solenoid for Rear Heater Control Valve. This kit fits only the early style valve with four screws at the top. It will not fit the later valve, with no screws, which cannot be disassembled.
Heater Control Valve-Heater Core 1997-2003 Vacuum actuated valve for heater
Heater Control Valve-Rear Heater Core 1992-2000 Electro-magnetic valve Used from 1992-mid 2000 Up to VIN 70 Y 015000 Valve Repair Kit available, see below
Heater Control Valve-Rear Heater Core 2000-2003 Electro-magnetic valve Used from Mid 2000 (from VIN 70 Y 015001) to 2003 Compare to unit shown below
Heater Hose Assembly #2 2001-2005 ***NO LONGER AVAILABLE***
NO LONGER AVAILABLE, DISCONTINUED BY VW
If you are in doubt as to which heater hose you need, a VW part number is located in white on all heater hoses.
Heater Hose Assembly 1997-2000 TYPE A *DISCONTINUED* DISCONTINUED /NO LONGER AVAILABLEVR6-12V models
Mounts on driver's side of firewall to heat exchangerThree hose connections and a sensor (included) on the plastic Tee. This is one of two possible hose types.
Heater Hose Assembly 1997-2000 TYPE B VR6-12V modelsThere are two hose connections and a sensor on the larger plastic Tee. This is one of two possible hose types.
Heater Hose Assembly 2001-2005 ***NO LONGER AVAILABLE***
NO LONGER AVAILABLE, DISCONTINUED BY VW
VR6-24V models only
This hose assembly is comprised of four hose sections, a hose tee and an air bleed valve.
Heater Hose Assembly 2001-2005 TYPE B ***NO LONGER AVAILABLE***
NO LONGER AVAILABLE, DISCONTINUED BY VW
VR6-24V models ONLY
Mounts on driver's side of firewall to heat exchangerThere are three hose setions, two hose tees and a temperature sensor on the larger plastic Tee. This is one of two possible hose types. This unit is only for models witj manually regulated heating and air conditioning.
Heater Hose-Inlet/Feed 1992-2003 Feed hose to heater core
Interior Air Temp Sampler Motor 1997-2003
Rear Heater Core 1992-2003 Located under third seat area for those vehicles that are so equipped.
