Exhaust Camshaft 2002-2006 2002-2006 For both OM612 and OM647 engines
Exhaust Clamp Bolt 2002-2006 & 2014+ 2.1L 4 CYL This bolt is used on 2002-2006 5 CYL engines, as well as 2014+ 2.1L 4 CYL engines
Exhaust Hanger 2002-2017 These rubber exhaust hangers are used in several locations throughout all Sprinter exhaust systems.
Exhaust Head Pipe 2002-2003 This is the header pipe, which is located just ahead of the diesel catalytic converter
Has flexible section and NO provision for an Oxygen Sensor, as the OM612 engine used in 2002-2003, did not use one.
See clamp shown below, which is also only used for these two model years.
Exhaust Head Pipe 2004-2006 This is the header pipe, which is located just ahead of the diesel catalytic converter
Has flexible section.
Exhaust Manifold Gasket 2002-2006
Exhaust Valve-OM612 2002-2003 2002-2003 OM 612 engine only
Exhaust Valve-OM647 2004-2006 OM 647 engine only
Intake Camshaft 2002-2003 2002-2003 OM612 engine only
Intake Camshaft 2004-2006 2004-2006 OM647 engine only
Genuine Mercedes part
Intake Manifold Gasket 2002-2006 Intake manifold to cylinder block
Intake Manifold Inlet Actuator 2004-2006 AKA: Idle Air Speed Motor/Servo, or Swirl Valve Actuator
Intake Valve-OM 612 2002-2003 Only for 2002-2003 OM 612 engine
Intake Valve-OM 647 2004-2006 Only for 2004-2006 OM 647 engine
Seal Ring-Turbocharger to Exhaust 2004-2006 & 2014+ 2.1L 4 CYL Located at joint between the turbocharger and the front pipe at the clamp area
This seal ring is used on 2004-2006 5 CYL engines, as well as 2014+ 2.1L 4 CYL engines
Turbocharger Exhaust Clamp TYPE 2 2004-2006 & 2014+ 2'1L 4 CYL Located at the joint between the turbocharger and the exhaust header pipe.
This is the tapered design.
Compare to your original before ordering, as there are two different types.
This clamp is used on 2004-2006 5 CYL engines, as well as 2014+ 2.1L 4 CYL engines